COB strip light · Shenzhen
COB strip light,
specified by the numbers
Five series, one specification language. Density, voltage, PCB width, cut interval, CRI and CCT for every model — so you can quote from the sheet instead of a photograph.
Indicative rendering of the COB light line, not a product photograph
Series
Five series, one specification language
Selection
Seven columns decide the model
Every product page carries the same seven fields. Pick the ones your project fixes, and the catalogue narrows to what will actually fit.
Laboratory
Tested at the bench, not in the brochure
Aging test
Every batch is run lit before it is packed.
Thermal shock
Boards cycle between hot and cold to test the solder joint.
Rewind and tension
Reels are pulled to catch a weak solder point or a lifted chip.
Where the strip gets used
Four starting points, each mapped to the series that usually fits. Open one to see the matching models.
About
A strip maker, not a catalogue reseller
Lumizhi builds COB strip light in Shenzhen across five series — single colour, tunable white, RGB and pixel, fixed wavelength, and mains voltage. Density, voltage, PCB width and cut interval are set per model, so a specification can be matched rather than approximated.
Every batch runs through aging, thermal shock and rewind checks before it is released. OEM and ODM work is quoted against the same fields you see on the product pages.
About Lumizhi
Enquiry
Send the run length, get the model
Tell us the length, voltage and colour temperature you need. If the layout is unusual, say so — a 48V board or a 15 m reel may remove a feed point you were planning.
- Model-level quotes, not a general price list
- OEM and ODM runs quoted against the same spec fields
- English catalogue available before you commit to a model